Rear Bumper Kit for Land Rover Defender L663 - Gloss BlackPart number: LRDB454-Blk
Gloss Black Rear Bumper Trim
for Land Rover Defender L663
This is a kit of Gloss Black trim sections for the rear bumper on the Land Rover Defender L663.
Land Rover designed the bumpers of the Defender to be modular - made of different sections clipped together so if damaged, you do not need to replace the whole bumper!
On most models these sections of the bumpers in this kit are painted silver but on higher spec vehicles they are painted gloss black specific to that spec i.e. X/X Dynamic etc.
Due to their location on the vehicle these parts are often scratched or damaged in use.
Gloss Black is also fitted to models with the extra 'Black Pack' option.
Included in the Rear Bumper Kit:
- Main centre section (where the number plate mounts to)
- Centre panel (fits into main section) - non-towbar type
- 2x Tow Eye Blanks ( not needed if you have the tow loops fitted )
- 2x Recess inserts (these sit either side of the bumper underneath the rear lights)
NOTE: You will need to swap over the camera bracket from your old bumper to the new one.
The centre panel supplied in this kit is not suitable if you have a towbar fitted - if you have a towbar you will need to source a suitable centre panel with the cut out (or paint your existing one gloss black).
This will fit all models - the 90, 110 and 130 models all have the same rear bumper!
All of the parts in this kit are replacement parts and not covers.
These spare parts may incorporate a third party design and are intended exclusively to be used to repair the vehicle to its original appearance.
See our other listings to purchase additional front bumper parts if you also need them i.e. corner sections etc.
This is not a genuine Land Rover item.
These are a straight replacement items - where applicable your existing fixings should be re-used, there are no fixings or clips supplied with this kit.
NOTE: You will need to swap over the camera bracket from your old bumper to the new one - you'll need to bond it into place on the new bumper (see photo).
If you are changing from a silver bumper you will have 2x silver pdc sensors so you'll need to either paint them black or you could use our pdc cover stickers - see item VNL108.
You will need to remove your rear bumper to fit these parts - see below video.
Which Vehicles will this fit ?
This item WILL fit the Land Rover Defender L663 - all models (90/110/130) - note the centre panel supplied in this kit is not compatible if you have a towbar fitted
- Choosing a selection results in a full page refresh.
- Opens in a new window.