Front Bumper Rubber End Cap for Land Rover DefenderPart number: LRD669-AM
Front Bumper Rubber End Cap ( non genuine )
for Classic Land Rover Defender
This listing is for a SINGLE end cap.
The classic Land Rover Defender front bumper has remained unchanged from the early series models to date apart from the addition of these rubber end caps when the TD5 was launched.
These can be fitted to any pre-TD5 bumper simply be drilling 2 holes as shown. These are a simple and easy fit to the later TD5 type bumpers as the holes are pre-drilled.
The end cap is symetrical so can be used on the left or right end of the bumper ( each end is the same )
To fit this end cap you will need to use the fitting pins (not supplied with this part) - Land Rover part number DZM100080 ( 4 per end cap )
This after market product is nearly identical to the genuine part - there is a slight difference to the surface finish - see attached picture.
Why not take a look at our other Defender accessories like polished stainless front bumpers.
These are NOT genuine Land Rover parts.
Drill holes in your bumper if not already present and fit end cap over the end of the bumper. Insert fitting pins.
Please see video below for whole bumper removal (including end caps)
Which Vehicles will this fit ?
This all defender models ( 90 / 110 / county / pickup etc ). This also fits the earlier series models
- Choosing a selection results in a full page refresh.
- Opens in a new window.