Rear Bumper Protector for Range Rover Evoque L538 - Stainless Steel
Stainless Steel Rear Bumper Cover
for Range Rover Evoque
Enhance the rear of your Range Rover Evoque by fitting one of these precision made stainless steel bumper step covers.
These covers will fit all Evoque models - 3 door and 5 door / Pure, Prestige and Dynamic.
The step has a fine "brushed" pattern which tends to wear better than fully polished versions and also matches the stainless steel inserts fitted to the rear boot step on some models.
The bumper protector will cover scratched and damaged areas which often appear if the boot is used frequently.
This step is fitted using the pre-applied automotive grade self adhesive tape - see below video.
This tread plate is supplied together with a alcohol based pre cleaning wipe and a tube of silicone adhesive to ensure maximum adhesion.
A subtle yet effective upgrade that can be fitted in minutes.
This is not a genuine Land Rover accessory.
Lift the whole tailgate.
Unpack the rear bumper cover and check the fit before removing the tape backing strips.
Apply some of the supplied silicone adhesive as shown in the video
Position in place and apply a little pressure.
Full adhesion will be reached in 24hrs.
See below fitting video. NOTE: The video shows a slightly different version - this item does not have a 'lip' at the front of the protector.
How to fit a stainless steel rear bumper step protector trim to a Range Rover Evoque - YouTube
Video will open in a new window
Which Vehicles will this fit ?
This WILL fit all of the Evoque models - this part of the car is the same on 3 and 5 door models and also the Pure / Prestige and Dynamic models are all the same in this area.
This WILL NOT fit any other Land Rover or Range Rover model.